SJ5000 - Missing LED plastic protection

Discussion in 'SJ5000 Series' started by SJRG, Jan 31, 2018.

  1. SJRG

    SJRG New Member

    Joined:
    Jan 20, 2018
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Hello,

    The plastic protection of the LED located near the top button (used to take videos) just went out and broke.
    Is there a website where I can find a new one ? Would you put something else to fix the problem (adhesive, mastic) ?

    Thank you very much in advance.
     
  2. drogar

    drogar New Member

    Joined:
    Feb 11, 2018
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    same problem here
     
  3. drogar

    drogar New Member

    Joined:
    Feb 11, 2018
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Bump
     
  4. Sulev Svilponis

    Sulev Svilponis Elite

    Joined:
    Aug 11, 2017
    Messages:
    525
    Likes Received:
    111
    Trophy Points:
    43
    Gender:
    Male
    Use a small drop of a transparent hot glue to replace the plastic protection of the LED. This should work ok.
    If you are not master of a hot glue gun, then just put a drop of the glue on a PVC film first and then apply it to the camera and mould it with your finger, if necessary.
     
  5. drogar

    drogar New Member

    Joined:
    Feb 11, 2018
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Thank you for an idea. My better half is a school teacher and a hot glue gun master !
     

Share This Page