SJ8-Pro FW1.2.4 and FPV lead. I am unable to get the camera to remote trigger via the DET line using PWM. I was advised by SCAM technical that this was possible before purchasing this camera, however I have only managed to get the camera to randomly take a picture or go into record mode. It usually locks up! I was using a GTI2P which triggers flawlessly using PWM. The SJ8-Pro was bought for the better image quality for use on my drone. The FPV lead has the following connections: GND: Ground Electrode CVBS: AV Signal Wire VBUS: USB Electrical Main Wire RX: GPS Signal Receiving Wire VCC: GPS Power Supply Wire DET: FPV Signal Controlling Wire Any advice appreciated.
Is it possible to trigger remote capture on sj8 pro with FPV cable with latest firmware? If it is how can we do that?