FOV not available when Gryo sensor is enabled?

Discussion in 'SJ6 LEGEND' started by SamTan, Jul 14, 2019.

  1. SamTan

    SamTan New Member

    Joined:
    May 22, 2018
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Occupation:
    Engineer
    Location:
    Singapore
    Hi, my SJ6 is on version 1.5.0 3 01 2018

    When I switch the gryo sensor to either Low or High setting, not only do I not see the hand icon on the rear display I also found that I cannot access to FOV and Distortion Correction setting.
    To access to FOV and Distortion Correction I have to go back and set the gryo sensor to Off.

    Is this normal?Or am I missing something here?
     
    SamTan, Jul 14, 2019
    #1
  2. Troy

    Troy Administrator Staff Member

    Joined:
    Feb 28, 2017
    Messages:
    10,279
    Likes Received:
    10,083
    Trophy Points:
    1,000
    Yes it is normal.
    The Gyro uses a crop of the image to play around with when stabilizing the image. Thus, both FOV and Distortion Correction which uses the similar technique as with Gyro, can't function at the same time. You just have to choose one. Hope this helps.
     
    Troy, Jul 15, 2019
    #2
    Mayur likes this.
  3. SamTan

    SamTan New Member

    Joined:
    May 22, 2018
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    1
    Gender:
    Male
    Occupation:
    Engineer
    Location:
    Singapore

    Thanks Troy for clearing this up.
    What about the hand icon when Gyro sensor is On? I don't see on the display.
     
    SamTan, Jul 21, 2019
    #3

Share This Page